Paint Question
4 posters
Page 1 of 1
Paint Question
I want to paint my new gearbox black, satin or matt, any body got any tips on what to use?
buick350- partner
- Posts : 1417
Join date : 2010-10-01
Age : 38
Re: Paint Question
I'd go for satin. Have a look at www.frost.co.uk some good bits on there.
escortosis- maniac poster
- Posts : 204
Join date : 2010-10-05
Age : 54
Location : Square left .. to 3 right...to absolute flat ..er .. oh fu**
Re: Paint Question
buick350 wrote:I want to paint my new gearbox black, satin or matt, any body got any tips on what to use?
I would use Hammerite aerosol, just make sure everything is clean and allow time as several coats will be required. With Hammerite you can't leave overnite and spray again the next day, it will craze so complete the job the same day, it's not cheap but what is, it's resistant to oil etc don't think you would be disappointed.
jake64- partner
- Posts : 825
Join date : 2010-10-03
Re: Paint Question
hamerite is fantastic if you get the one with the built in kurust , you can spary it onto rusty metal i did a whole engine it that stuff and i do recon mondeo rear subframes in it az well , just haz to b clean and no loose rust , i normaly spray brake cleaner on to get the oil off ,coz it avapourates quickly , but panel wipe will do the same
baz- partner
- Posts : 1111
Join date : 2010-10-03
Age : 42
Re: Paint Question
it survives 200f+ temperatures then? need special primer on aluminium aswell
buick350- partner
- Posts : 1417
Join date : 2010-10-01
Age : 38
Re: Paint Question
buick350 wrote:it survives 200f+ temperatures then? need special primer on aluminium aswell
Hammerite do a "High Heat" up to 600 degrees C but only in Matt Black and only in an aerosol but no primer needed.
jake64- partner
- Posts : 825
Join date : 2010-10-03
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|